My Preferred Dealer
Find a Specific Product: Oils, Lubricants and Fuels
Image of BigMood

Oils, Lubricants and Fuels

Quality fuel specially formulated to keep your STIHL running strong

When you own a STIHL, you care about quality and demand the best performance. Keep your 2-cycle engine in peak condition with a regular maintenance routine and premium-quality STIHL oils, premixed fuels and lubricants.

STIHL 2-cycle engine oils are specifically formulated for all STIHL chainsaws and offer outstanding engine cleaning and lubrication. A considerable amount of effort has been put into developing STIHL engine oil, bar and chain oil, and maintenance chemicals; they are designed to offer maximum protection under the most severe professional applications. They are also ideal for low-emission 2-cycle engines. 

Eliminate the hassle of mixing your own fuel mixture with STIHL MotoMix® premixed fuel. It’s clean, convenient and can be stored longer than fuel you mix on your own. STIHL MotoMix® is created with premium high-octane gasoline and the superior protection of STIHL HP Ultra Oil.

  1. 7 years ago
    excellent product for your stihl
    I use this fuel in my saws and weed wacker. Although it's a little more expensive then mixing your own fuel the perks of using this fuel are unbelievable. My saws only get used in the fall/winter months for firewood and after a full summer of sitting you can go out and fire them off with no hassle. Not only do they start right up they also run as if you just used them yesterday. Excellent work on stihls behalf.
  2. 3 years ago
    Great stuff
    I was not the most impressed with the cost of this fuel, but after over a year of using it, I have come to like it. Using gas & oil mix, I'd use 1-2 gallons of gas & oil mix a year. The 1 gallon container would not get used in a timely manner, and I ended up pouring the gas/oil mix in my old gas tractor, which did not seem to mind it. On my gas powered Stihl equipment, using gas/oil, I would drain the fuel out, I'd start it up, and let it run till it died, after each use, if going to set idle ... read more for a while. Don't have to do that anymore using the pre-mix fuel. I wouldn't mind if the price came down a bit. If I was a heavy fuel user, I would probably still be mixing the gas/oil. Unfortunately, no fuel suppliers near where we live sell ethanol free fuel anymore. If using this MotoMix fuel eliminates carb issues, and helps my Stihl equipment last longer, so be it. A note to Stihl, go back to the round cans. They seem to pour better that the square can, at least that is my take on it. I now pour the square can of fuel into the round can, that was before the square one. Dealer stated that the square can has a handle, well, so what.
  3. 2 years ago
    Great fuel but pricey
    I've been using Stihl and other brand trimmers for the better part of 16 years. Sure they will run on mixed pump gas but it will mean shorter maintenance intervals and possibly damage if you don't run the required octane as preignition/detonation becomes more likely. A bad fuel/oil ratio can cause a lean condition and also lower the octane rating as oil inherently drops the octane of fuels. The Moto mix is peace of mind with the added bonus of lengthening the warranty. For all day use on a ... read more big job I would have to rely on pump 93 with Stihl oil since I know I can go thru the most of the fuel can fast enough that it wont need to be stored for very long. Then give it a fresh tank of moto mix towards the end if the job to clean out the pump mix and ready it for storage.
  1. 6 years ago
    Chuck your other gas cans!
    A glowing review of a gas can? Yes sir! Other spill-mitigation systems can be cheap, difficult to use, and easy to break. I've gone through several. But this one? Push the button. No twisting cheap plastic rings into cheap plastic grooves and praying it doesn't break, no frustration at all actually, and I love the clear stripe that lets you see exactly how much gas is in the thing. It's a point-and-push operation.
  2. 7 years ago
    This may be the last gas can you'll have to purchase!
    I purchased one of each size of the NO-SPILL fuel containers from my STIHL dealer. The gas cans are easy to fill and to use with the flow button. You will NEVER overfill your STIHL equipment again! VERY HIGH QUALITY product which should last you a lifetime. Don't settle for a "cheap" gas can when you can own the BEST!
  3. 2 years ago
    Acceptable Eco Compliant Gas Can
    I’ve managed to hang onto my “old” non automatic closing to avoid the “hardware store “ quality auto close nozzles that spill gas everywhere and break almost instantaneously when used... I’ve had a few experiences and constantly question if this is progress... BUT this No-Spill Fuel Container is a different story all together. It is made well enough and seems to hold up under use. The price is not bad and it simply works! It is nice to be able to meter the fuel into the machines with a push of a ... read more button and not have to press the nozzle into the opening to release the fuel... usually onto the floor.. Anyway, this is a different animal and if you are tired of paying good money for hardware store eco junk, this is the gas can you want! It is well worth any extra expense! I recommend it 100%!!
  1. 1 year ago
    Platinum Bar Oil is a CUT-ABOVE the Rest !
    I was skeptical at first browse of this product. I thought, at the time, there was no good reason to swap from my many years of using Woodcutter Bar & Chain Oil. This is my first year using Platinum Bar & Chain Oil. What I have discovered is that it takes less overall quantity of this Oil to achieve the same level of lubrication provided by it's predecessor. Another benefit is this Oil is not as temperature-sensitive as the Woodcutter Bar & Chain Oil is. In other words, it will perform ... read more satisfactorily at somewhat lower temperatures before you ultimately need to switch over to Winter Bar & Chain Oil. It will take you some time to get used to having less visible Oil on your Chain, but the proof of proper lubrication is a cool-running Bar that isn't burning the paint off! However, if you have one of the newer Saws, be prepared to turn-up the Oil Quantity setting to near maximum level...even when using Platinum Bar & Chain Oil. I found the "E" setting on my new MS-362,461, & 661 to be too lean with 20", 25", & 32" Bars, respectively. So, I guess this means that the Woodcutter Bar & Chain Oil may be an unsatisfactory choice for proper lubrication on the newer Saws with lower-volume Oil Pumps & newer Bars with smaller Oil Delivery Holes.
  2. 1 year ago
    Platinum Protection for my Equipment
    I’m running this in all of my saws and it’s the best I’ve ever seen. It’s a clear color so pay attention when filling the tank, but the performance is top shelf! I’ve used it well below freezing and it flows just fine, especially when the Saw is good and warm. It protects in both the hot/humid weather and the cold. I do t use separate bar lines for cold weather any more. Just the platinum for all conditions! It does not clog up my tank or pump either. The tackiness is great and it stays in place ... read more very well even at high chain speeds. All in all it’s the best chain/bar Lube I’ve ever used and it’s well worth the modest cost difference.
  3. 1 year ago
    Excellent Product
    I have tried cheaper brands with poor results. This oil keeps the chain oiled and bar cooler.
  1. 1 year ago
    Winter Bar & Chain Oil Will Flow When Your Coffee's Frozen !
    I use Winter Bar & Chain Oil in place of Platinum Bar & Chain Oil on the coldest of cutting days. The summer Oils will turn to molasses or jello at some point. The end result of that could be a "toasted" Bar! If you are still using Woodcutter Bar & Chain Oil, your switch-over to Winter Bar & Chain Oil should occur sooner as it thickens quicker than Platinum Bar & Chain Oil will at a given temperature. Remember, the newer Saws deliver less Oil to the Bar & Chain than the older models do, so ... read more your switch-over point may be more critical depending which Oil & Saw you have. Stihl, please color-code these Oils so we know what is in our Saw!!!
  2. 1 year ago
    For the really cold days
    I keep a quart around for the really cold days. In all honesty when the saw is warmed up I just run the Platinum Bar Lube and I haven’t had any issues. For the really really cold days this does flow better through the pump and onto the bar. It protects well but I switch when the temperature gets above 20F.
  1. 6 years ago
    HP Ultra oil
    High Power Ultra oil. Absolutely amazing oil when mixed with 89/91 grade gasoline. I only use this oil in my Stihl equipment and REALLY makes a difference. The engines run SO smooth and clean and the gasoline seems to last longer too! I can not recommend this oil enough. Try it and you will the difference in the first run!
  2. 2 years ago
    Take Care of your INVESTMENT!
    Look, Stihl power equipment deserves to be taken care of. This is especially important during break-in periods when friction & heat will be at their highest. Stihl will increase your product warranty when you purchase HP Ultra Oil in combination with your equipment purchase! Ask your dealer for details. I often wonder if I had been using this oil in my FS-550 a few years back...it wouldn't have seized up! Trust me, I do use it now in my MS-362, MS-661, BR-600, FS-460, & FS-560. That is way too ... read more much of an investment in equipment not to take care of. Friction performance is way better than standard 2-cycle mix.
  3. 7 years ago
    good oil
    I started using this oil when it first came out, its the only oil that the local store sells, its not that much higher in price, over the lower grade of oil, the only thing I don't like about it is that it doesn'e have much color to the gas when mixed, whish Stihl would make it a darker color.
  1. 3 years ago
    Good product, avoid at low temperatures
    My boss bought this stuff for our crew because we go through 40 to 50 (or more) gallons of bar oil per work season and none of us liked the idea of spraying petroleum all over the forest. I also bought some for myself for other cutting jobs and I like it a lot. However, in temps lower than -15 F, it's too viscous and doesn't lubricate well. I switched back to regular cold weather oil after scorching the bar on my 362. It also smokes if your chain is dull and you're running the saw fast (had a ... read more coworker do this often)...cold weather oil does that too if run in warm air temps. However, in normal conditions it smells interesting, does a good job lubricating the saw, supposedly breaks down quickly, and landowners like the idea of it...good stuff!
  2. 7 years ago
    Good product, but pricey
    I like this oil for it's health and environmental benefits. It also has very good cold flow characteristics. The regular oil flows very slowly and is hard to poor in winter conditions. This oil flows well and is easy to pour. I haven't seen any difference in wear on bar or chains through 2 gallons of use.
  3. 4 years ago
    Safer to use.
    BioPlus is a better smelling oil. Kind of smells like french fries when you really put 'er to work!
  • 2019-11-13
  • bvseo_sps, prod_bvsp
  • cp_1
  • tr_17
  • loc_en_US, PRD
  • clientname_STIHL, pc_6, tc_6
  • bvseo_sdk, net_sdk, 2.3.0.0
  • CLOUD, getContent, 16ms
  • SPOTLIGHTS, CATEGORY